16
RQT9640
No response when [
1
/
;
] is pressed.
≥
Disconnect the USB device and then reconnect it.
Alternatively, turn the unit off and on again.
The USB drive or its contents cannot be read.
≥
The USB drive format or its contents is/are not compatible
with the unit (
>
4).
≥
The USB host function of this product may not work with
some USB devices.
Slow operation of the USB flash drive.
≥
Large file size or high memory USB flash drive takes longer
time to read.
The elapsed time displayed is different from the
actual play time.
≥
Copy the data to another USB device or backup the data and
reformat the USB device.
[SC-HC37DB]
DAB+ reception is poor.
≥
Keep the antenna away from computers, televisions, other
cables and cords.
≥
Use an outdoor antenna (
>
8).
A beat sound or noise is heard while receiving
radio broadcast.
≥
Confirm the antenna(s) are properly connected. (
>
8)
≥
Adjust the position of the antenna.
≥
Try to keep a certain amount of distance between the
antenna and AC mains lead.
≥
Try to use outdoor antenna if there are buildings or
mountains nearby.
≥
Switch the television or other audio player off or separate it
from the unit.
≥
Keep this unit away from mobile phones if the interference is
apparent.
[SC-HC37]
A low hum or noise is heard during AM
broadcast.
≥
Keep the AM antenna away from this unit, other cables and
cords.
[SC-HC37]
AM Stations cannot be selected.
Change the AM frequency step.
1
Press [RADIO] to select “AM”.
2
Press and hold [RADIO] on the unit.
After a few seconds the display changes to show the current
lowest frequency. Continue to hold the button down. The lowest
frequency changes and the step is changed.
Cannot charge or operate.
≥
Check that the iPod/iPhone is connected firmly. (
>
9)
≥
The battery of the iPod/iPhone is depleted. Charge the iPod/
iPhone, and then operate again.
≥
When unexpected operation occurs while using the iPod/
iPhone, connect the iPod/iPhone again or try to restart the
iPod/iPhone.
The remote control doesn’t work properly.
≥
The remote control and this unit are using a different code.
(
>
17, “REMOTE ”)
The following messages or service numbers may
appear on the unit’s display.
“--:--”
≥
You plugged the AC mains lead in for the first time or there
was a power failure recently. Set the time (
>
14).
“ADJUST CLOCK”
≥
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥
Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
≥
The unit has been left unused for about 30 minutes and will
shut down in a minute. Press any button to cancel it.
“CANNOT SET”
≥
Select an audio source other than “VTUNER”.
“CHECKING CONNECTION”
≥
The unit is checking the connected iPod/iPhone. If this
display keeps appearing, make sure that iPod/iPhone is
inserted correctly and try again (
>
9).
“ERROR”
≥
Incorrect operation is performed. Read the instructions and
try again.
“F61”
≥
There is a power supply problem. Consult the dealer.
“ILLEGAL OPEN”
≥
Sliding door is not in correct position. Turn the unit off and on
again. If this display appears again, consult the dealer.
“IPOD OVER CURRENT ERROR”
≥
The iPod/iPhone is drawing too much power. Remove the
iPod/iPhone and turn the unit off and on again.
USB operations
Radio
iPod/iPhone operations
Remote control
Messages
SC-HC37DBGN_37GN~RQT9640-1L.book Page 16 Tuesday, February 28, 2012 11:30 AM
