19
RQT0A52
EN
GL
IS
H
The following messages or service numbers
may appear on the unit’s display.
“A NO DEV”
“B NO DEV”
≥
The USB device is not inserted correctly. Read
the instructions and try again (
l
8).
“ADJUST CLOCK”
≥
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥
The play and/or record timer is not set. Adjust the
play and/or record timer accordingly.
“AUTO OFF” (blinks)
≥
The unit has been left unused for about 20
minutes and will shut down within a minute. Press
any button to cancel it.
“CAN’T REC”
≥
You cannot do recording when the USB device is
locked. Unlock the USB device and try again.
“DEVICE FULL”
≥
You cannot do recording because the remaining
recording time of the USB device is less than the
total time of the music source. Change to a USB
device which has enough recording time and do
the recording again.
“ERROR”
≥
Incorrect operation is performed. Read the
instructions and try again.
“ERROR” (during recording)
≥
You cannot select other playback source
(e.g.: USB etc.) or press [
:
/
6
] or [
5
/
9
]
during recording. Stop the recording function.
“F
” (“ ” stands for a number.)
≥
There is a problem with this unit.
≥
Write down the displayed number, disconnect the
AC mains lead and consult your dealer.
“GUITAR SWITCH ON”
≥
You cannot use the Karaoke function when
[
B
MIC
C
] is at the pushed-down position.
Change it to the released position. (
l
16)
“INVALID”
≥
You cannot select the vocal cancel, echo and key
control when the Karaoke mode is off.
Press [KARAOKE] on the unit to select “ON
KARAOKE”. (
l
16)
“NO PLAY”
“UNSUPPORT”
≥
Examine the content. You can only play
supported format. (
l
3)
≥
The files in the USB device can be corrupted.
Format the USB device and try again.
≥
The unit may have a problem. Turn the unit off
and then on again.
“NO TRACK”
≥
There is no album or track in the USB device.
“PLAYERROR”
≥
You played an unsupported MP3 file. The system
will skip that track and play the next one.
“REC ERROR”
≥
You disconnected the USB device while
recording. Connect the USB device and do
recording again.
“REMOTE ” (“ ” stands for a number.)
≥
The remote control and this unit are using
different codes. Change the code on the remote
control.
– When “REMOTE 1” is displayed, press and hold [OK] and
[
] on the remote control for at least 4 seconds.
– When “REMOTE 2” is displayed, press and hold [OK] and
[USB] on the remote control for at least 4 seconds.
“TEMP NG”
≥
The temperature protection circuit has been
activated, and the system will switch off. Let the
unit cool down before switching it on again.
≥
Check that the ventilation opening of the unit is
not obstructed.
≥
Ensure this unit is well ventilated.
“USB OVER CURRENT ERROR”
≥
The USB device is drawing too much power.
Remove the USB device and turn the unit off.
“VBR”
≥
The system cannot show the remaining play time
for variable bit rate (VBR) tracks.
Messages
19
SC-CMAX5_E~RQT0A52-R.book 19 ページ ２０１５年６月１２日 金曜日 午前１１時２２分
