Before using
16
LSQT1121
ª
How to turn the power on and off with
the LCD monitor/viewfinder
When the power switch is set to [ON], the power
can be turned on and off with the LCD monitor
and the viewfinder when the unit is in Tape
Recording Mode or Card Recording Mode.
1
Open the LCD monitor out or extend the
viewfinder to use.
(
-17-
)
≥
The LCD monitor or viewfinder will be
activated.
2
Close the LCD monitor and retract the
viewfinder.
≥
The power will not turn off unless the LCD
monitor is closed and the viewfinder is
retracted.
≥
The Status indicator automatically goes off
and the power turns off. (If quick start is set to
[ON] (
-18-
), the unit goes into quick start
standby mode and the Status indicator lights
green.)
≥
The power does not turn off even if the
LCD monitor is closed and the viewfinder
is retracted while recording on a tape.
3
Open the LCD monitor or extend the
viewfinder to turn the power on and use the
Camcorder again.
≥
The Status indicator lights red and the power
turns on.
Setting date and time
When the Camcorder is turned on for the first
time, [SET DATE AND TIME] will appear.
≥
Select [YES] and press the center of the
joystick. Perform steps 2 and 3 below to set the
date/time.
If the screen shows the incorrect date/time, then
adjust it.
≥
Set to Tape Recording Mode or Card
Recording Mode.
1
Set [BASIC] >> [CLOCK SET] >> [YES].
(
-23-
)
2
Move the joystick left or right in order to
select the item to be set. Then move the
joystick up or down to set the desired value.
≥
The year will change as follows:
2000, 2001, ..., 2089, 2000, ...
≥
The 12-hour clock is used.
3
Press the joystick to determine the setting.
≥
The clock function starts at [00] seconds.
ª
About date/time
≥
The date and time function are driven by a built-
in lithium battery.
≥
Make sure to check the time before recording
because the built-in clock is not very accurate.
ª
Recharging the built-in lithium battery
≥
If [
0
] or [--] appears when the Camcorder is
turned on, then the built-in lithium battery has
run down. Use the steps below to charge the
battery. When turning on the power for the first
time after charging, [SET DATE AND TIME] will
appear. Select [YES] and set the date and time.
Connect the AC adaptor to the Camcorder or
attach the battery to the Camcorder, and the
built-in lithium battery will be recharged. Leave
the Camcorder as is for approx. 24 hours, and
the battery will drive the date and time for
approx. 6 months. (Even if the [OFF/ON] switch
is set to [OFF], the battery is still being
recharged.)
OFF
ON
OFF
ON
OFF
ON
S5660.book 16 ページ ２００６年１０月３０日 月曜日 午後６時５６分
