Before using
14
LSQT1121
Power supply
ª
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥
Battery charging time. (
-15-
)
≥
We recommend using Panasonic batteries.
(
-11-
,
-72-
)
≥
If you use other batteries, we cannot guarantee
the quality of this product.
≥
If the DC Cable is connected to the AC adaptor,
then the battery will not get charged. Remove
the DC Cable from the AC adaptor.
1
Connect the AC Cable to the AC adaptor
and the AC Jack.
2
Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
ª
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
ª
Connecting to the AC outlet
1
Connect the AC Cable to the AC adaptor
and the AC Jack.
2
Connect the DC Cable to the AC adaptor.
3
Connect the DC Cable to this product.
≥
The output plug of the AC Cable is not
completely connected to the AC adaptor jack.
As shown in
1
, there is a gap.
≥
Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
ª
Attaching the battery
Push the battery against the battery holder and
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY] lever, slide the
battery to remove it.
≥
Hold the battery with your hand so it does not
fall.
≥
Before removing the battery, be sure to set the
[OFF/ON] switch to [OFF].
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
1
BATTERY
S5660.book 14 ページ ２００６年１０月３０日 月曜日 午後６時５６分
