![background image](http://html.mh-extra.com/html/panasonic/pt_at6000e/pt_at6000e_service-manual_270756046.webp)
1. 5. Clog Sensor Calibration
1. 5. 1. Required equipments
1. PC : Use it as adjustment use.
2. Communication cable : D-sub 9pin (male/emale RS-232C straight)
3. Software :
[
Service ORCA11.exe
]
Adjustment software is downloaded from the projector service homepage.
1. 5. 2. Preparation
1. Please clean the air filter before starting the steps.
The air filter should be replaced when cleaning is ineffective.
(If the filter is dirty and clogged, the correction may not be
completed properly.)
1. 5. 3. Adjustment method
1.Push the power button of the projector and let a lamp turn on. (The signal input is unnecessary.)
* Push the INPUT SELECT button, and please stop "Auto-signal search".
2. Start up service software
[
Service ORCA11.exe
]
with a computer.
* Please close another software before using the "Service software".
3. Select language and click the [ OK ] button.
4. 1) Select the Serial Port of the computer.
2) Select a model number.
(Case of AT6000, select the AE8000.)
3) Click the [ Adjustment ] button.
5. Click the [ FLTR Sensor ] button.
6. Select the sea level height of the work place and click the [ Do Now ] button.
7. In approx. 15 minutes, the "Sensor correction" window closes automatically and completes the correction.
* Turn off the main power supply, and please turn on the main power supply again.
* This operation should be done with the main body is completely assembled and set on the floor and the adjuster
legs are set in the main body. (A state of Disassembly, cannot correct it.)
* Install the projector so that cold air or hot air from air conditioners does not come in to direct contact with the
air intake port or air exhaust port.
* Please carry it out after “Data Transfer” of Micom Data.
2. Connect the RS-232C termanal of projector
and PC with a RS-232C cable.
Computer
Projector
RS-232C cable (Streight)
Progress window
* When error message is displayed,
1)Turn off the main power supply,
and please turn on the main power
supply again.
2)Please carry it out from 1 procedure
once again.
③
①
②
ADJ - 6
Содержание PT_AT6000E
