Panasonic PT-VZ580, Инструкция по эксплуатации (Функциональное руководство)

Страница: 39 / 131

2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
Æ
page 26)
f
Refer to “Navigating through the menu” (
Æ
page 50) for the operation of the menu screen.
3) Press the input selection buttons on the remote control or the <INPUT SELECT> button on the control
panel to select the input signal. (
Æ
page 41)
f
The buttons that can be used on the remote control are as follows.
<COMPUTER 1> button, <COMPUTER 2> button, <VIDEO> button, <HDMI 1> button, and <HDMI 2>
button
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
Æ
page 43)
5) Adjust the size of the image to match the screen with the zoom lever.
6) Adjust the vertical projection position with the vertical lens shift dial.
7) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
8) Adjust the focus again with the focus lever.
9) Adjust the size of the image to match the screen with the zoom lever again.
Note
f
When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed, the
[INITIAL SETTING] screen is displayed after projection starts. Refer to “When the initial setting screen is displayed” (
Æ
page 37).
Switching off the projector
2)
1) 3)
2)
1)
1) Press the power <
v
/
b
> button.
f
The [POWER OFF] confirmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power <
v
/
b
> button again.)
f
Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> on the projector lights in
orange. (The fans keep running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> on the projector lights or blinks in red.
f
The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights or blinks in red.
4) Disconnect the plug of the power cord from the outlet.
Note
f
While the power indicator <ON(G)/STANDBY(R)> is lighting in orange, the luminous lamp is being cooled down and the projector cannot be
turned on. Wait until the power indicator <ON(G)/STANDBY(R)> starts lighting or blinking in red to turn on the projector again.
f
Even if the power is turned off by pressing the power <
v
/
b
> button, the projector consumes power if the power plug is connected
to the outlet.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is
restricted, but the power consumption during standby can be conserved.
ENGLISH - 39
Chapter 3 Basic Operations - Switching on/off the projector