Network
ENGLISH -
71
Settings
Set [EAP], [USER NAME],
and [PASSWORD].
EAP
1
: Select the EAP
setup in the
RADIUS server
1
. Types of
EAP that can be
selected are as
follows.
PEAP
1
(MS-
CHAPv2
1
),
PEAP
1
(GTC
1
),
EAP-TTLS
1
(MD5
1
),
EAP-TTLS
1
(MS-CHAPv2
1
), EAP-FAST
1
(MS-CHAPv2
1
), EAP-FAST
1
(GTC
1
)
USER
NAME:
Input a user
name used for
authentication
(excluding
spaces)
(maximum 64
characters).
PASS
WORD:
Input a
password
used for
authentication
(maximum 64
characters).
1: “Glossary” (
Æ
page
117 – 118)
Note
If you are unable to connect to the wireless LAN
z
through the access point even after performing the
steps in “Projector settings (
Æ
page
76)”, contact the
manufacturer of the access point.
When using EAP, the projector needs to be set according
z
to the setting of the RADIUS server. Check with the
network administrator for the setting of the RADIUS
server.
When using an EAP together with an access point with
z
invalid SSID broadcast, select WAP-EAP or WAP2-EAP
for the authentication method even if the authentication
method of the access point is WPA-EAP/WPA2-EAP.
Default settings of [USER 1] - [USER 3]
The following settings as [USER1] - [USER3] in the
wireless LAN are set before the projector leaves the
factory.
SSID
Panasonic Projector
DHCP
Off
IP address
192.168.11.100
Subnet mask
255.255.255.0
Default gateway
192.168.11.1
Mode
AD HOC
Authentication
OPEN
Encryption
NONE
Channel
11
DNS 1/DNS 2
NONE
Press ▲▼◄► to select [Set], and press
5 )
<ENTER> button.
Save the current network settings
Note
When configuration is completed, you need to select [Set]
z
and press the <ENTER> button. At this point, select [Back]
to go back to the previous screen (2/3), or select [Cancel]
to cancel the configuration change.
Sending image from iPad / iPhone /
iPod touch
By using the dedicated application, you can send the
PDF file or the JPEG image which stored on your iPad
/ iPhone / iPod touch to the projector for projecting.
For details, please enter the following URL.
http://panasonic.net/avc/projector/
Projector name
You can change the projector name to be displayed
on the network.
Press ▲▼ to select [Projector name],
1 )
and press <ENTER> button.
Select characters with the ▲▼◄►
2 )
buttons and press the <ENTER>
button to enter the projector name.
Select [BS] to delete one character selected
with the cursor in the input box and press the
<ENTER> button.
Select [Set] with the ▲▼◄► buttons
3 )
and press the <ENTER> button.
Select [Cancel] to undo the changes and then
press the <ENTER> button.
Select [YES] or [No] with the ▲▼
4 )
buttons and press the <ENTER>
button.
Note
[Name
z
□□□□
] (
□□□□
is four-digit number) is set
before the projector leaves the factory.
