Panasonic PT-VW360D, Руководство по эксплуатации

Страница: 76 / 133

Adjusting the volume
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press
as
to select [VOLUME].
4) Press
qw
to adjust the level.
Operation Adjustment Range
Press the
w
button.
Increases the volume.
0 ~ 63
Press the
q
button. Decreases the volume.
Adjusting the balance
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press
as
to select [BALANCE].
4) Press
qw
to adjust the level.
Operation Adjustment Range
Press the
w
button.
Increase the volume of the right channel.
L16 ~ R16
Press the
q
button.
Increase the volume of the left channel.
Setting the mute status
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press
as
to select [MUTE].
4) Press
qw
to switch the item.
[OFF] Outputs the audio.
[ON] Turns off the volume temporarily.
Setting the audio output during standby
1) Press
as
to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The [AUDIO SETTING] screen is displayed.
3) Press
as
to select [IN STANDBY MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF] Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode. At this time, press the <VOL +> button / <VOL -> button on the
remote control or
qw
buttons on the control panel to adjust the volume.
Note
f
When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK] (
x
page 74), even if [IN STANDBY MODE] is set to
[ON], audio cannot be output during standby.
f
When the power is switched off at the digital signal input with [IN STANDBY MODE] set to [ON], the audio may be interrupted in the process
of the projector entering the standby mode.
Setting audio input selection
Choose the audio input terminal for each input signal.
76 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu