Panasonic PT-TX340, Руководство по эксплуатации, Страница: 56 / 112

56 - ENGLISH
[Setting] menu
On the menu screen, select [Setting] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (
x
page 46) for the operation of the menu screen.
[On start]
Set the startup method which will be applied when the projector is powered on after connecting the power plug to outlet.
1) Press
as
to select [On start].
2) Press the <ENTER> button.
3) Press
as
to switch the item.
f
The items will switch each time you press the button.
[Off] Starts up in the standby mode.
[On]
Starts the projection immediately.
[Standby mode]
Set the standby power consumption. Change the setting whether or not use the network function.
1) Press
as
to select [Standby mode].
2) Press the <ENTER> button.
3) Press
as
to switch the item.
f
The items will switch each time you press the button.
[Eco] Select this item to reduce power consumption during standby.
[Normal] Select this item to use the network function or the serial communication function during standby.
Note
f
If [Standby mode] is set to [Eco], you cannot use network functions and some RS-232C commands.
[High land]
Change the setting according to the altitude in which you use the projector.
1) Press
as
to select [High land].
2) Press the <ENTER> button.
3) Press
as
to switch the item.
f
The items will switch each time you press the button.
[Off] When using the projector in the elevation of below 700 m (2 297').
[On 1] When using the projector in the elevation of above 700 m (2 297') and below 1 400 m (4 593').
[On 2] When using the projector in the elevation of above 1 400 m (4 593') and below 2 700 m (8 858').
Note
f
It is set to [Off] when using the projector in the elevation of below 700 m (2 297'). It is set to [On 1] when using the projector
in the elevation of above 700 m (2 297') and below 1 400 m (4 593'). It is set to [On 2] when using the projector in the
elevation of above 1 400 m (4 593') and below 2 700 m (8 858'). Failure to do so may shorten the life of the internal parts
and result in malfunctions.
f
Do not set the projector in the elevation of 2 700 m (8 858') or above, otherwise it may shorten the life of the internal parts
and result in malfunctions.
f
When it is set to [On 1] or [On 2], the fan noise becomes louder and fan speed increases.
[Lamp control]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press
as
to select [Lamp control].
2) Press the <ENTER> button.
3) Press
as
to switch the item.
f
The items will switch each time you press the button.
f
You can also press the <LAMP> button on the remote control. (
x
page 42)
Chapter 4 Settings - [Setting] menu