Panasonic PT-TW381R, Руководство по эксплуатации, Страница: 71 / 136

ENGLISH - 71
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (
x
page 49) for the operation of the menu screen.
[STATUS]
You can check the using status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The
[STATUS]
screen is displayed.
[SIGNAL]
[NAME]
Displays the name of input signal.
[FREQUENCY]
Displays the scanning frequency of input signal.
[RUNTIME]
[PROJECTOR]
Displays the actual usage time of projector.
[LAMP]
Displays the usage time of the luminous lamp.
[SERIAL NUMBER] [PROJECTOR]
Displays the serial number of the projector.
[VERSION] [MAIN/SUB]
Displays the main/sub firmware version of the projector.
Note
f
After replacing the lamp unit, reset the lamp runtime manually. Otherwise, the lamp runtime displayed in [PROJECTOR SETUP] menu
→ [STATUS] → [RUNTIME] → [LAMP] may differ from the actual lamp runtime. Refer to “Resetting the lamp runtime” (
x
page 116) for
details.
f
For the network status, refer to the [NETWORK] menu → [NETWORK STATUS]. (
x
page 86)
[COMPUTER1 INPUT SETTING]
Switch the input setting of the <COMPUTER 1 IN> terminal.
1) Press
as
to select [COMPUTER1 INPUT SETTING].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[RGB/YPBPR]
Select when inputting the RGB signals or YP
B
P
R
(YC
B
C
R
) signals to the <COMPUTER 1 IN> terminal.
[Y/C]
Select when inputting the Y/C signals to the <COMPUTER 1 IN> terminal by using the D-SUB - S Video
conversion cable (model number: ET-ADSV).
[COMPUTER2 SELECT]
Switch the input/output of the <COMPUTER 2 IN/1 OUT> terminal.
1) Press
as
to select [COMPUTER2 SELECT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[COMPUTER2 IN]
Select when inputting the RGB signals or YP
B
P
R
(YC
B
C
R
) signals to the <COMPUTER 2 IN/1 OUT> terminal.
[COMPUTER1 OUT]
Select when the RGB signals or YP
B
P
R
(YC
B
C
R
) signals input to the <COMPUTER 1 IN> terminal is output
from the <COMPUTER 2 IN/1 OUT> terminal.
Note
f
When COMPUTER2 input is selected, [COMPUTER2 SELECT] cannot be set.
f
You cannot switch to COMPUTER 2 input when [COMPUTER2 SELECT] is set to [COMPUTER1 OUT].
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
2) Press the <ENTER> button.
f
The [PROJECTOR ID] screen is displayed.
3) Press
as
to select a projector ID.
Chapter 4 Settings - [PROJECTOR SETUP] menu