Panasonic PT-TW381R, Руководство по эксплуатации, Страница: 40 / 136

40 - ENGLISH
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
INPUT
AV MUTE
VOL+
VOL-
3)
5)
3)
1) Roughly adjust the focus of the image with the focus ring. (
x
page 42)
2) Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
x
page 72)
f
Refer to “Navigating through the menu” (
x
page 49) for the operation of the menu screen.
3) Press the <INPUT> button on the control panel or the input selection (<COMPUTER 1>, <COMPUTER
2>, <HDMI 1/2>, <VIDEO>, <MEMORY VIEWER/NETWORK>) buttons on the remote control to select
the input signal.
4) Adjust the projection angle of the projector with the adjustable feet. (
x
page 43)
5) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
6) Adjust the focus again with the focus ring again.
Powering off the projector
INPUT
AV MUTE
VOL+ VOL-
1)
3)
1)
2)
2)
1) Press the power <
v
/
b
> button.
f
The [POWER OFF] confirmation screen is displayed.
2) Press
as
to select [OK], and press the <ENTER> button on the remote control or the
w
button on
the control panel.
(Or press the power <
v
/
b
> button again.)
f
Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> lights in orange. (The fan
keeps running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> lights or blinks in red.
f
The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights or blinks in red.
4) Disconnect the plug of the power cord from the outlet.
Note
f
While the power indicator <ON(G)/STANDBY(R)> is lighting in orange, the luminous lamp is being cooled down and the projector cannot be
turned on. Wait until the power indicator <ON(G)/STANDBY(R)> starts lighting or blinking in red to turn on the projector again.
f
When packing the projector for transportation and storage, please make sure that each indicator is off.
f
Even if the power is turned off by pressing the power <
v
/
b
> button, the projector consumes power if the power plug is connected
to the outlet.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is
restricted, but the power consumption during standby can be conserved.
Chapter 3 Basic Operations - Powering on/off