Projecting an image
Basic Operation
E
NGLISH - 23
Projecting an image
Confirm the connections of the peripheral devices
(
Æ
page 17, 18) and power cord (
Æ
page 19). Switch on the
power (
Æ
page 21) and the projector starts projecting. Select the input signal and adjust the image.
Selecting the input signal
1 ) Switch on the connected devices.
When playing a connected DVD player, if
SIGNAL
SEARCH
in the
DISPLAY OPTION
menu is set
to
ON
, the input signal is detected and projected
automatically when the projector is switched on.
(
Æ
page 37)
Set the
z
INPUT GUIDE
under the
ON-SCREEN
DISPLAY
in the
DISPLAY OPTION
menu to
DETAILED
. If the projector cannot detect any
input signal, the Computer connection guidance
will display. (
Æ
page 36)
2 ) Select an input signal.
The image selected with the
INPUT SELECT
button is projected. (
Æ
page 24)
Note
Change the setting of the
z
PICTURE
menu
according to the connected device and DVD, video
tape, etc., to be played. (
Æ
page 31)
Confirm the aspect ratio of the screen and image.
z
Select the optimum aspect ratio. (
Æ
page 33)
Positioning the image
When setting up the projector for the first time or setting up at a new place, you must perform the following operations.
1 ) Adjust the vertical angle of the projector.
Place the projector at the right angle from the screen.
z
Press the adjuster buttons and adjust the vertical projection angle. Then, adjust the projected image to the
z
center of the screen.
Adjust the projection size and focus.
2 )
Remove the Zoom-Focus ring cover
z
(
Æ
page 12) and turn the zoom and focus rings to adjust the projected
image. After adjusting, be sure to install the Zoom-Focus ring cover to protect from dust.
Zoom ring
(ZOOM)
Focus ring
(FOCUS)
Remarks
When you adjust the zoom after adjusting the focus, you may need to adjust the focus of the image again.
z
If keystone distortion occurs, see “KEYSTONE”.
z
(
Æ
page 32)
