Panasonic PT-LB51E, Руководство по эксплуатации

Страница: 37 / 56

OPTION menu
E
NGLISH - 37
Settings
You can check how long the lamp has been used.
You can set the off timer to switch off the
POWER
of the
projector after a certain period of time automatically
when no signal is detected. Press
I H
to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
You can switch the projector start up status for when the
Mains lead
is connected. Press
I H
to select the
required option.
OFF
The projector will start from the
standby mode or the projecting
mode.
(The projector will start from the
same status as when the mains lead
was disconnected.)
ON
The projector will start from the
projecting mode.
You can turn off the function of the control panel buttons
on the projector body. Press
I H
to select the required
option.
INVALID
Invalidate the control panel buttons
Confirmation screen will be
displayed.
VALID
Validate the control panel buttons
You can turn off the
AUTO SETUP
function for when the
COMPUTER
signal is detected.
AUTO
When the projector detect a
COMPUTER
signal, adjust the
projected image position
automatically for
SIGNAL SEARCH
,
DOT CLOCK
and
CLOCK PHASE
.
BUTTON
Only when the
AUTO SETUP
button
is pressed, the projected image
position will be adjusted for
DOT
CLOCK
and
CLOCK PHASE
. See
“Remote control” on page 12.
You can turn off the auto signal detecting system.
ON
Detect the input signal from the
terminals and project the image.
OFF
Deactive
When installing the projector, select the projection
method according to the projector position. Press
I H
to cycle through the options. See “Projection method” on
page 17.
LAMP RUNTIME
NOTE:
•
LAMP RUNTIME
is a relevant matter for lamp
replacement timing. See “Replacing the Lamp unit” on
page 43.
POWER OFF TIMER
DIRECT POWER ON
NOTE:
• When the projector is started from the projecting mode,
pressing the
POWER
button procedure is skippable.
CONTROL PANEL
DISABLE
15 MIN.
20 MIN.
25 MIN.
30 MIN.
35 MIN.
60 MIN.
55 MIN.
50 MIN.
45 MIN.
40 MIN.
AUTO SETUP
NOTE:
• Usually the recommended setting is
AUTO
.
SIGNAL SEARCH
NOTE:
•
SIGNAL SEARCH
is not available when any input
signal is projecting.
• Usually the recommended setting is
ON
.
INSTALLATION
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting in the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting in the ceiling and
projecting from rear