Chapter 4
Settings — [PROJECTOR SETUP] menu
104 - ENGLISH
[COMMAND]
Detailed settings of
[COMMAND]
Description
[INPUT]
[VIDEO]
Switches the input to VIDEO.
[RGB1]
Switches the input to RGB1.
[RGB2]
Switches the input to RGB2.
[DVI-D]
Switches the input to DVI-D.
[HDMI]
Switches the input to HDMI.
[SDI]
Switches the input to SDI.
[LAMP SELECT]
[SINGLE]
Turns on one lamp. (The lamp with shorter runtime will
automatically light.)
[DUAL]
Turns on two lamps. (The lamp with shorter runtime will
automatically light.)
[TRIPLE]
Turns on three lamps. (The lamp with shorter runtime will
automatically light.)
[QUAD]
Turns on all four lamps.
[P IN P]
[OFF]
P IN P function is not used.
[USER1]
Lays out the sub-screen with the settings of [USER1].
[USER2]
Lays out the sub-screen with the settings of [USER2].
[USER3]
Lays out the sub-screen with the settings of [USER3].
11)
Press the <ENTER> button.
f
The command is fixed and
n
is displayed at the left of the selected command.
f
After the command is fixed, press the <MENU> button to close the detailed setting screen.
12)
Press
asqw
to select [STORE], and press the <ENTER> button.
Note
f
If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen.
Set the time and command again.
f
To delete a command already set, press the <DEFAULT> button on the remote control at the screen in Step
5)
, or select [DELETE] at the
screen in Step
6)
and press the <ENTER> button.
f
If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f
The operating time will be the local time. (
x
page 108)
f
If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with this function may not be executed.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press
as
to select [STARTUP INPUT SELECT].
2)
Press
qw
to switch the item.
f
The items will switch each time you press the button.
[LAST USED]
Keeps the input selected last.
[VIDEO]
Sets the input to VIDEO.
[RGB1]
Sets the input to RGB1.
[RGB2]
Sets the input to RGB2.
[DVI-D]
Sets the input to DVI-D.
[HDMI]
Sets the input to HDMI.
[SDI]
Sets the input to SDI.
[RS‑232C]
Set the communication conditions of the <SERIAL IN>/<SERIAL OUT> terminal.
Setting the communication condition of the <SERIAL IN> terminal
1) Press
as
to select [RS‑232C].
2) Press the <ENTER> button.
f
The
[RS‑232C]
screen is displayed.
