Panasonic PT-DZ13KU, Руководство по обслуживанию, Страница: 20 / 121

10. CLOG SENSOR CALIBRATION
Calibrate the clogging sensor circuit.
* Execute this after EEPROM IC3509/IC3518 /A-P.C.Board or clogging sensor (M2-P.C.Board) is replaced.
* Please refer to Clause 1 of SECTION 3 (Adjustments) for the procedure.
3. 3. 2. Additional function of each menu
1. [PICTURE] menu
AI WINDOW is added to the setting of the sub menu "dynamic iris".
- Sets the APL detection area.
2. [POSITION] menu
DVI EQUALIZER is added to a sub menu.
- When noise contamination to DVI input caused by long cable or external device, set this item so that
the noise decreases.
3. [DISPLAY OPTION] menu
The following items are added to setting of sub menu "SDI IN".
XYZ TO RGB SETTING
- FACTORY SETTING: Uses the value of FACTORY Yxy conversion factor to the original data of XYZ
→
RGB.
- MEASURED: Uses the value of MEASURED Yxy conversion factor to the original data of XYZ
→
RGB.
- REC709: Uses the value of REC709 Yxy conversion factor to the original data of XYZ
→
RGB.
- DCI P3: Uses the value of DCI P3 Yxy conversion factor to the original data of XYZ
→
RGB.
XYZ TEST PATTERN
- WHITE
：
10%
～
100%
- DARK GRAY
：
1
～
10
- COLOR
：
Red/Green/Blue/Cyan/Magenta/Yellow 1
～
2
4. [PROJECTOR SETUP] menu
The following items are added to an indication screen of the sub menu "STATUS ".
1) Page 2
- FPGA VERSION FPGA version (FOGA1/FPGA2/FPGA3)
- BALLAST VERSION Ballast software version
2) Page 4
- VERTICAL TILT Vertical angle
- HORIZONTAL TILT Horizontal angle
3) Page 6
- MAIN VERSION Main Microcomputer Software Version
- FPGA VERSION FPGA version (FOGA1/FPGA2/FPGA3)
- BMP VER. Version of Bitmap data
- ENG VER.
～
JPN VER. Version of the each font data (English/Russian/Korean/Chinese/Japanese)
4) Page 7
- FM R/FM G/FM B VERSION Version of the each Formatter Software Version
(Configuration/Main Application/Sequence/De-Gamma)
5) Page 8
- TEMP
℃
Intake air temperature / Exhaust air temperature / Optical module temperature
- P.SENSOR Brightness Sensor value
- VOLT Voltage of LAMP1/LAMP2
- AIR FLOW Sensor value / AD conversion value, Sensor Correction value/ AD conversion value
- FAN MODE FAN control mode (LOW/MID/HIGH)
- CLOG Fan rev up state due to clogging of air filter
(+0:NONE, +1:LEVEL1, +2:LEVEL2, +3:LEVEL3, Life extension:LIFE)
- R-EXST Exhaust (R) fan status [Rotational speed]
- C-EXST Exhaust (C) fan status [Rotational speed]
- L-EXST Exhaust (L) fan status [Rotational speed]
- INTAKE1 Intake1 fan status [Rotational speed]
- INTAKE2 Intake2 fan status [Rotational speed]