Panasonic PAN1760A, Технические характеристики товара

Страница: 26 / 31


PAN1760A Bluetooth Module
6 Regulatory and Certification Information
Product Specification Rev. 1.1 Page 26
6.1.6 RF Exposure
To comply with FCC RF Exposure requirements, the OEM must ensure that
only antennas from the Approved Antenna List are installed

6.1.5 Approved
Antenna List.
The preceding statement must be included as a CAUTION statement in
manuals for products operating with the approved antennas in the previous
table to alert users on FCC RF Exposure compliance.
Any notification to the end user of installation or removal instructions about the
integrated radio module is not allowed.
The radiated output power of the PAN1760A with a mounted ceramic antenna
(FCC ID: T7V1760A) is below the FCC radio frequency exposure limits.
Nevertheless, the PAN1760A shall be used in such a manner that the
potential for human contact during normal operation is minimized.
End users may not be provided with the module installation instructions.
OEM integrators and end users must be provided with transmitter operating
conditions for satisfying RF exposure compliance.
6.2 Innovation, Science, and Economic Development (ISED) for
Canada
English
The PAN1760A is licensed to meet the regulatory requirements of Industry Canada (IC).
License ID: IC: 216Q-1760A
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to
clarify any regulatory questions and ensure compliance for SAR and/or RF exposure limits.
Users can obtain Canadian information on RF exposure and compliance from
www.ic.gc.ca .
This device has been designed to operate with the antennas listed in

6.1.5 Approved
Antenna List , having a maximum gain of +0.9 dBi. Antennas not included in this list or having a
gain greater than +0.9 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms. The antenna used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Due to the model size, the IC identifier is displayed in the installation instruction only and it
cannot be displayed on the module’s label due to the limited size.