Before Use
8
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor
(36)
of the Movie Camera
and press an appropriate button.
≥
Distance from the Movie Camera: Within
approximately 5 metres
≥
Angle: Within approximately 10
o
in the
upward, and 15
o
in the downward and
horizontal directions from the central axis
≥
The above operating ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥
Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥
If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-15-
)
Setup on the Remote Controller:
[VCR1]: Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]: Press the [
E
] Button and [
∫
] Button
simultaneously.
2
WARNING
Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 100
x
C or
incinerate. Keep the Button-Type battery out
of the reach of children. Never put
Button-Type battery in mouth. If swallowed
call your doctor.
10˚
15˚
15˚
15˚
(36)
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥
The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown
1
.
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
ª
Using the Battery
Before use, fully charge the Battery.
≥
We recommend using Panasonic’s Battery.
≥
We cannot guarantee the quality of this Movie
Camera when batteries of other companies are
used.
1
Attach the Battery to the AC Adaptor and
charge it.
≥
Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥
The [CHARGE] Lamp lights up, and charging
starts.
1
400GN.book 8 ページ ２００４年６月３日 木曜日 午後１時４９分
