Panasonic NV-FJ6130PN, Руководство по обслуживанию

Страница: 39 / 104

VHS Alignment Tape (VFMS0003H6)
Post Adjustment Driver (VFK0329)
H-Position Adjustment Driver (VFK0330)
6.2.2.2.1. ENVELOPE OUTPUT ADJUSTMENT
The height of the P2 and P3 Posts replacement part is preadjust at the factory.
Purpose:
To achieve a satisfactory picture and secure precise tracking.
Symptom of Misadjustment:
If the envelope is output poorly, much noise will appear in the
picture. Then the tracking will lose precision and the playback
picture will be distorted by any slight variation of the tracking
control circuit.
Equipment Required:
Post Adjustment Driver (VFK0329)
1. Insert the alignment tape.
2. Press and hold VCR/TV button and CH DOWN buttons on VCR
together over 5 seconds in power off condition.
The power comes on and the unit goes into service mode.
3. Play back the alignment tape.
4. To enter Tracking center mode, press PLAY button in Play back
mode. "TRACKING CENTER" will be displayed on the TV monitor.
5. Connect the oscilloscope to TP3002 on the Video Signal Process
Section of the Main C.B.A. Use TP6205 as a trigger.
6. Confirm that the RF envelope is flat enough (V1/V-max. is 0.7 or
more). If not, with Post Adjustment Driver, adjust P2 and P3 post
height so that the envelope waveform becomes as flat (V1/V-max.
is 0.7 or more) as possible (Noenvelope drop). If the envelope
drop appears on the left-half of the waveform, adjust P2 post
height. If the envelope drop appears on the right-half of the
waveform, adjust P3 post height.
CAUTION:
Overtightening P2 and P3 posts may cause the threads to strip.
Note:
It will be possible to confirm Step 6 according to following steps.
1. Release the Tracking center mode.
39