Panasonic NN-K575MF, Руководство по обслуживанию

Страница: 54 / 65

14.3. Digital programmer circuit troubleshooting guide
SYMPTOM STEP CHECK RESULT CAUSE/CORRECTIONS
No display when oven is first plugged in.
Oven is dead. 1 Fuse pattern of DPC Normal STEP 2
Open (NOTE) Shorted Circuit of
ZNR,L.V.T., Oven Lamp
etc.Replace DPC
2 Low voltage transformer (LVT)
secondary voltage Abnormal 0V LVT
Normal
→
Step 3
3 IC-1 pin 16 voltage
(Emitter of Q11) Abnormal ZD11, Q11
Normal = 5V Display
NOTE
Procedure of fuse pattern repairing is as follows:
1. When the fuse pattern (PF2) opens.
(1) Remove the jumper wire (PF1).
(2) Insert the removed jumper wire (PF1) to “(PF2)” position and solder it. If both “PF1” and “PF2” fuse patterns are open, replace DPC.
2. When the fuse pattern (PF4) opens.
(1) Remove the jumper wire (PF3).
(2) Insert the removed jumper wire (PF3) to “(PF4)” position and solder it. If both “PF3” and “PF4” fuse patterns are open, replace DPC.
NOTE:* At the time of these repairs, make visual inspection of the varistor for burning damage and examine the transformer with tester for
the presence of layer short-circuit (check primary coil resistance).
If any abnormal condition is detected, replace the defective parts.
No key input
1 Membrane switch continuity Abnormal Membrane switch
Normal IC-1
No beep sound 1 IC-1 pin 29 voltage Abnormal IC-1
Normal BZ, Q224
Power relay A(RY-2) does not turn on
even though the program has been set
and the start pad is tapped 1 IC-1 pin 9 voltage while
operation Abnormal IC-1
Normal = 5V
→
Step 2
2 Short circuit between collector
and Emitter of Q223. Still does not turn on RY-2
RY-2 turns on Q223
No microwave oscillation at any power
setting 1 IC-1 pin 7 and pin 34 voltages
while operation at high power Abnormal IC-1
Normal
→
Step 2
7---5V
2 Q220 transistor Abnormal Q220
Normal RY-1
Dark or unclear display 1 Replace display and check
operation Normal DISPLAY
Abnormal IC-1
Missing or lighting of incorrect segment 1 Replace IC-1 and check
operation Normal IC-1
Abnormal DISPLAY
H97/H98 appears in window and oven
stops operation. Program High power for
1 minute and conduct following test
quickly, unless H97/H98 appears and
oven stops. NEW H.V. 1 Unplug CN702(2 pin)
connector and measure
voltage between terminals 0V 1. Latch Switch
2. DPC/Power Relay
AC line voltage of 120V
→
Step 2
2 Unplug CN701(3 pin)
connector and measure pin 1
voltage 0V DPC
Approx. AC 3V Magnetron
CONTINUED FOR SENSOR MODELS
Auto sensor cooking does not operate
normally.
(Steam Sensor cooking does not
detect steam from foods.) 1 Steam sensor terminal voltage
by using high impedance
tester (20k
Ω
/ V),while
breathing on metal surface of
sensor
Abnormal = 0V Steam sensor
Normal>10-30mV IC-1
29
NN-G463 / NN-S443 / NN-S423 / NN-S413 / NN-413