English
En-7
Installation and Connection
Examine your microwave oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such
as dents, broken door latches or cracks in
the door. If you
fi
nd any damage, notify your
dealer immediately. Do not install a damaged
microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE
PROPERLY EARTHED FOR PERSONAL
SAFETY.
If your AC outlet is not grounded, it is the
personal responsibility of the customer to
have it replaced with a properly grounded wall
socket.
Operation voltage
The voltage has to be the same as speci
fi
ed on
the label on the oven. If a higher voltage than
speci
fi
ed is used, it may cause a
fi
re or other
damages.
Placement of the Oven
This oven is intended for counter-top use only.
It is not intended for built-in use or for use
inside a cupboard.
1.
Oven must be placed on a
fl
at, stable
surface 85 cm above the
fl
oor, with rear of
oven placed against a back wall.
2.
When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug or
operating a circuit breaker.
3.
For proper operation, ensure a suf
fi
cient air
circulation for the oven.
Counter-top use:
If one side of the oven is placed
fl
ush to
a wall, the other side or top must not be
blocked. Allow 15 cm of space on the top of
the oven.
Counter-top
15cm
Open
4.
Do not place this oven near an electric or
gas cooker range.
5.
The feet should not be removed.
6.
This oven is only for household usage.
Do not use outdoors.
7.
Avoid using the microwave oven in high
humidity.
8.
The power cord should not touch the
outside of the oven. Keep the cord away
from hot surfaces. Do not let the cord hang
over the edge of a table or work top. Do not
immerse the cord, plug or oven in water.
9.
Do not block the air vents on the top and
back of the oven. If these openings are
blocked during operation the oven may
overheat. In this case the oven is protected
by a thermal safety device and resumes
operation only after cooling down.
10.
This appliance is not intended to be
operated by means of an external timer or
separate remote control system.
Attention: Hot Surfaces
F0003BS30EP_Eng_08_20150423.indd 7
F0003BS30EP_Eng_08_20150423.indd 7
2015/4/23 13:33:22
2015/4/23 13:33:22
