Panasonic NN-C2000P, Руководство по обслуживанию

Страница: 16 / 42

2. Remove the door C from door E by carefully pulling outward
starting from upper right hand corner.
3. Separate the door A from the door E by freeing 8 catch
hooks on the door A.
4. Remove door key spring and door key.
After replacement of the defective component parts of the
door, reassemble it and follow the instructions below for
proper installation and adjustment so as to prevent an
excessive microwave leakage.
1. When mounting the door to the oven, be sure to adjust the
door parallel to the bottom line of the oven face plate by
moving the upper hinge and lower hinge in the direction
necessary for proper alignment.
2. Adjust so that the door has no play between the inner door
surface and oven front surface. If the door assembly is not
mounted properly, microwave may leak from the clearance
between the door and oven.
8.7. Turntable motor
1. Remove 2 screws holding motor cover.
2. Disconnect 2 lead wires from turntable motor.
3. Remove 2 screws holding turntable motor.
8.8. Inverter PCB
1. Remove 2 screws holding inverter bracket to oven chassis.
2. Remove A screw holding air guide.
3. Remove grounding lead wire.
4. Remove 2 screws holding noise filter PCB. (some models
only)
5. Remove all lead wires from inverter PCB.
6. Slide left and take out inverter PCB with brackets.
7. Remove A screw holding inverter PCB to bracket from
bottom.
8. Remove 3 screws holding inverter PCB to bracket.
9. Remove inverter PCB from its bracket by releasing several
catch hooks.
10. When re-install, make sure to place grounding plate in its
place.
16
NN-C2000P / NN-C2000W