-
2-
Earthing Instructions
WARNING: THIS APPLIANCE MUST BE EARTHED.
This appliance is supplied with a moulded three pin mains plug for your
safety and convenience. A 13 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that the replacement fuse has
a rating of 13 amps and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark or the BSI mark on the body of the
fuse.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE
SOCKET OUTLET THEN THE FUSE SHOULD BE REMOVED AND
THE PLUG CUT OFF AND DISPOSED OF SAFELY AND AN
APPROPRIATE ONE FITTED. THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO
ANY 13 AMP SOCKET.
If a new plug is to be fitted, please observe the wiring code as shown
below. If in any doubt, please consult a qualified electrician.
IMPORTANT:
The wires in this mains lead are coloured in accordance
with the following code: Green-and-yellow: Earth. Blue: Neutral. Brown:
Live.
As the colours of the wire in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected
to the terminal in the plug which is marked with the letter E or by the
Earth symbol
or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal in
the plug which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal
in the plug which is marked with the letter L or coloured RED.
Do not immerse cord, plug or oven in water. Keep cord away from
heated surfaces. Do not let cord hang over the edge of table or work
top. Do not plug your oven in via an extension cable as this can be
dangerous. It is important to plug the oven directly into a wall socket.
Unpacking Your Oven
If the plug contains a removable fuse cover, you must ensure that
it is refitted when the fuse is replaced. If you lose the fuse cover,
the plug must not be used until a replacement cover is obtained. A
replacement fuse cover can be purchased from your local
Panasonic Dealer.
HOW TO REPLACE THE FUSE
Open the fuse compartment with a screwdriver
and replace the fuse.
Voltage & Power
The voltage used must be the same as specified on this
microwave oven. Using a higher voltage than that which is
specified is dangerous and may result in a fire or other type of
accident causing damage.
1.
Examine Your Oven
Unpack oven, remove all packing material, and examine the oven
for any damage such as dents, broken door latches or cracks in the
door. Notify dealer immediately if unit is damaged. Do NOT install if
unit is damaged.
2.
Guarantee Card
Fill out and post the pre-addressed guarantee card.
3.
Cord
If the supply cord of this appliance is damaged, it must be replaced
by the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
4.
Door Seal
The appliance should be inspected for damage to the door seals
and door seal areas. If these areas are damaged the appliance
should not be operated until it has been repaired by a service
technician trained by the manufacturer.
For Your Safety
