– 28 –
4. Set the desired cleaning cycle by touching the appropriate Number Pads. (Up to
9999 hours)
[Example]: Touch Number Pads “1”, “0” and “0” for 100 hours.
To Program the Second Stage
5. Touch Start Pad. The display will show the length of time (in hours) between
cleaning the Air Filter you have programmed in or the original time preset by the
manufacturer.
6. Set the desired cleaning cycle by touching the appropriate Number Pads. (Up to
9999 hours)
[Example]: Touch Number Pads “6”, “0” and “0” for 600 hours.
7. Touch Prog Pad.
This completes the procedure to program time between cleaning of the Air Filter.
8. After 3 seconds, “0” will appear in the Digital Display Window. The oven is now
ready for use.
Note: When the total hours used reach the time for the first stage, the beep tone
will sound. When the total hours used reach the time for the second stage,
“FILt” sign appears in Digital Display Window and the beep tone will sound.
Remove the Air Filter and clean it. (See page 12.)
Touch Stop/Reset Pad for 2 seconds to clear the display.
The counter will start over from “0” after it is cleared.
To display the filter cleaning alarm counter
1. Open the door and leave it open.
2. While touching Start Pad, touch Number Pad “5”.
After 3 seconds, “0” will appear in the Digital Display Window.
N.B. If the oven cuts out after short operation, check the Air Filter is clean before
calling an engineer.
O. Oven Lamp
The oven can not be programmed until the program lock feature is deactivated.
(See page 24, K. To Deactivate Program Lock.)
Oven Lamp settings when the door is open
To turn Oven Lamp settings OFF
1. Open the door and leave it open.
The oven lamp will turn on, and “0” will appear.
(Continued on next page.)
How to Operate
Содержание NE-1878
Страница 35: ... 35 ...