Panasonic NE-1878, Руководство по эксплуатации

Страница: 26 / 36

– 26 –
M. To Select Beep Tone Options
The oven can not be programmed until the program lock feature is deactivated.
(See page 24, K. To Deactivate Program Lock.)
The beep tone can be set for loudness—(4 Levels), length of tone—(3 Options), pitch of tone—(3 Options)
and pitch of filter cleaning alarm—(3 Options). You can select the combination of loudness, length and pitch
that best suits your needs.
The beep tone is set at the factory to the loudest level (#3), to 3 beeps and to normal pitch.
The filter cleaning alarm will sound when the total cooking time reaches the set time (in hours).
To Select Loudness Level
1. Open the door and leave it open.
The oven lamp will turn on. “0” will appear in the display.
2. Touch Prog Pad first and then touch Start Pad.
“3 bEEP” and pattern of beep sound settings indicator “1” will appear in the
Digital Display Window and “PROG” will blink.
3. Select the desired sound loudness level by touching Start Pad.
Repeated touching of Start Pad will lower the loudness of the tone all the way to
silent. The tone will sound at its loudness level and the Digital Display Window will
display loudness level in digits (3 to 0—loud to silent) followed by the word “bEEP”.
[Example]: 3 bEEP—Loudest (Factory Setting)
1 bEEP—Low
2 bEEP—Mid 0 bEEP—Silent
4. Touch Prog Pad again, and “PROG” will stop blinking, and the set loudness of
beep tone will appear for 3 seconds. Then “0” will appear.
To proceed to set length of beep tone, touch Start Pad before “0” is displayed after
Step 4.
To Select Length of Tone
There are 3 options for the length of beep tone at the end of heating cycle.
1st. 3 beeps (Factory Setting)
2nd. Short beeps for 60 seconds
3rd. “Beep” sounds for 5 seconds, and then 3 beeps sound 30 seconds later and
again 60 seconds later. (Beep reminder functions to prevent food from being
forgotten in the oven.)
5. Within 3 seconds after touching Prog Pad at Step 4, touch Start Pad.
A. “PROG” will blink.
B. Current length of beep tone will blink.
C. The display changes to 1st, 2nd, and 3rd each time Start Pad is touched (in
the bottom left corner).
6. When the desired length of tone has been selected, touch Prog Pad again.
“PROG” will stop blinking, and the set length of tone at the end of heating cycle
will appear for 3 seconds, then “0” will appear.
To proceed to set pitch of beep tone, touch Start Pad before “0” is displayed after
Step 6.
(Continued on next page.)
How to Operate