T
roubleshooting
Error Display
29
Symptoms
Points to be checked
T
ime
Time indication increases
or does not decrease
- Time indication is approximate. Remaining time is
corrected during operation and displayed.
Operation time is longer
than the time indication.
Operation does not stop
even after the preset time.
- The operation time may be longer if laundry is
concentrated on one side or the water supply or
drainage is not good.
(P. 28 “U 11” “U 14”)
Main unit
No operation
- Power failure?
- Is the lid closed completely?
- Has the power fuse blown or the breaker tripped?
- Is the power plug inserted completely?
- Is the water faucet turned on?
- Did you press “Start”?
- Is the timer preset?
Cannot change process
settings (after start-up).
- Process settings can be changed during wash
process by pressing “Pause”. To change the
program or settings after the end of wash process,
turn the power off and on again.
W
ash
No water supply
- Is the water faucet turned on?
- Water outage?
- Is the water supply
fi
lter clogged with dirt?
(P. 23)
Water is supplied in the
middle of wash process.
- If the water level drops, water is added automatically.
- With a large amount of laundry, water is added
several times automatically.
The water level is too high
for the amount of laundry.
- If laundry is wet or there is water in the tub before
operation, the water level may be higher.
The water level is too low
for the amount of laundry.
- With light clothes (of synthetic
fi
bre, etc.), the water
level may be lower.
Rinse/Spin
Operation started with
rinse, but water is not
supplied.
- If there is no water in the tub, water is supplied after
spin.
- If there is water in the tub, water is supplied after
water discharge.
Operation suddenly
changes to rinse process in
the middle of spin.
Only spin is desired, but
operation starts with rinse.
- If clothes are concentrated on one side of the
tub, the washing machine automatically corrects
unevenness by starting rinse process.
(Place clothes as evenly as possible.)
Irregular rotation during
spin
- The tub rotation speed is adjusted to reduce foaming
during spin.
Troubleshooting