9
INCUBATOR COMPONENTS
1. Inner door:
It is made of tempered glass. However, do not force the door.
2. Control panel:
Refer to page 10.
3. Separation plate:
Do not place objects directly on the plate.
4. Heater box (inside):
The heater is attached under separation plate.
5. Leveling foot:
Can be adjusted by screws. Turn the screw counterclockwise to shorten the length
of the leveling foot.
6. Gasket:
Be careful not to scratch the gasket.
7. Handle:
Pull the knob of inside of the handle to open the door.
8. Shelf support:
This can be adjusted to change the height.
9. Temperature sensor (installation position):
Be careful not to allow objects to touch or scratch the
sensor.
10. Exhaust air vent:
Do not put anything on this unit as an exhaust air vent may become hot during
operation. Make sure that the exhaust air vent is not blocked so that a temperature is controlled
correctly.
11. Key lock switch:
This switch is to prevent a set value from being changed by accidentally
pressing a key on the control panel. Turn on this switch to set the key-lock so that the set value
can not be changed.
Note:
Turn off this switch when inputting the set value.
12. Main power switch with circuit breaker:
Main switch for all power. When the operation of the
unit is stopped by this circuit breaker, contact our sales representative or agent after disconnected the
power supply plug.
CAUTION
Do not touch an air vent during operation, as this may cause burn injury.
