13
3.8.
Thermal Overload
Replacement
3.8.1.
Removal
1. Remove motor, as shown in motor replacement section.
2. Remove wire nut from the lead wire that contains the ther-
mal protector. Remove old thermal protector and replace
with new thermal protector. Reconnect wire nut to thermal
overload. Replace lead wire containing protector wires
back into the groove.
3.8.2.
Installation
1. Place the motor back into the dust compartment, follow-
ing the instructions given in the motor replacement sec-
tion.
3.9.
Motor Replacement
3.9.1.
Removal
1. Remove the dust cover by grasping the top near the on-
off switch and pulling sharply out toward you.
2. Remove the lower plate, agitator assembly, belt, the plas-
tic shaft, and the nozzle housing as instructed in the
respective removal sections.
3. Turn the vacuum over to the front side.
4. Remove the four (4) screws from the motor case and then
remove the motor case.
5. Disconnect the motor leads and remove the motor.
Remove the motor support rubber (rear), noise suppres-
sor, and the motor support rubber (front). Place these
items on the new motor.
3.9.2.
Installation
1. Place the motor back into the dust compartment with
brushes aligned parallel to the front edge of the dust com-
partment.
2. Rewire per the Pictorial Diagram.
3. Replace the motor case and the four (4) screws.
4. Turn the vacuum back over and replace the plastic shaft,
light bulb assembly, nozzle housing, belt, agitator assem-
bly, and lower plate according to the respective installa-
tion instructions.
