Panasonic MC-UL862, Руководство по эксплуатации

Страница: 8 / 10

This vacuum cleaner has a thermal cut-out which
automatically trips to protect the vacuum cleaner from
overheating. If a clog prevents the normal flow of air to the
motor, the thermal cut-out turns the motor off automatically to
allow the motor to cool in order to prevent possible damage to
the vacuum cleaner.
To correct problem: If this occurs, turn the vacuum cleaner
off and unplug the vacuum cleaner from the mains outlet to
allow the vacuum cleaner to cool and the thermal cut-out to
reset. Check for and remove clogs, if necessary. Also
check and clean/replace any clogged filters. Wait
approximately forty (40) minutes before switching on the
vacuum cleaner. The motor protector will not reset if the
vacuum cleaner is not turned off even if the vacuum
cleaner has cooled down.
H) MOTOR PROTECTOR
Motor Protector
This vacuum cleaner has a motor protector by-pass valve
which automatically opens to provide cooling air to the
motor when a clog prevents the normal flow of air to the
motor. If the by-pass valve opens to prevent motor
overheating and possible damage to the vacuum cleaner,
you will notice a change of sound as air rushes through the
valve opening.
To correct problem: See the TROUBLE-SHOOTING
guide (page 13).
NOTE: The motor protector may open when using
attachments or when cleaning new carpet, due to reduced
airflow by the attachments themselves or by new carpet
fluff filling the dust bin quickly. See the TROUBLE-
SHOOTING guide (page 13).
I) THERMAL CUT-OUT
CAUTION:
Do not block motor protector.
- 7 - - 12 -
1 4
Secondary Filter
Screen
1 5
If the vacuum cleaner does not seem to have adequate
suction, first check if the dust bin is full or if a filter is clogged.
Check the hose area.
Remove extension hose by grasping the hose collar,
twisting, and pulling straight off.
Visually inspect the hose and the base area into which the
hose is connected.
Remove any visible clog.
Re-connect the extension hose to the dust bin port
assembly.
Plug in the vacuum cleaner and turn it on.
Stretch the hose to maximum length and then allow the hose
to return to its storage length.
Turn the vacuum cleaner off and unplug the vacuum cleaner.
Remove dust bin and check secondary filter screen for clogs.
If the dust bin and filter areas and the hose areas are free of
clogs, check the nozzle area.
Return the vacuum cleaner to the upright position before
plugging into an electrical outlet.
G) BLOCKAGES