10
3 REPLACEMENT INSTRUCTIONS
3.1.
Dust Cover
3.1.1.
Removal
1. Remove dust bin.
2. Remove adjustable handle and unplug the vacuum
cleaner. Press the handle release pedal and lay the vac-
uum cleaner down.
3. Remove five (5) screws that secure the dust cover.
4. Carefully lift dust cover from body.
3.1.2.
Replacement
1. Carefully place dust cover onto body.
2. Reinstall the five (5) screws removed from disassembly.
3. Re-install dust bin.
NOTE:
For general servicing, it is necessary to eliminate pinch-
ing of any wire during reassembly. After servicing any electrical
component or electrical enclosure, the vacuum cleaner should
be reassembled and checked for dielectric breakdown or cur-
rent leakage.
3.2.
Mains Lead
3.2.1.
Removal
1. Remove dust bin and dust cover as outlined in the Dust
Cover Removal section.
2. Remove the two (2) screws that secure the tool caddy.
and then remove the tool caddy.
3. Remove the two (2) cord stopper screws, the wire con-
nectors, and wire tie, if present.
3.2.2.
Installation
1. Insert the mains lead (mains lead replacement only) with
approximately five (5) inches of new mains lead extend-
ing into the dust compartment. This distance is to be mea-
sured from the cord stopper to the end of the longest lead
wire of the mains lead.
NOTE:
Never reuse a cord stopper. Always install a new cord
stopper whenever the old one is removed.
2. Install the new cord stopper, the two (2) cord stopper
screws and the wire connectors.
NOTE:
For general servicing, it is necessary to eliminate pinch-
ing of any wire during reassembly. After servicing any electrical
component or electrical enclosure, the vacuum cleaner should
be reassembled and checked for dielectric breakdown or cur-
rent leakage.
3.3.
ON/OFF Switch Replacement
3.3.1.
Removal
1. Remove the dust cover as outlined in Dust Cover
Removal and Replacement section.
2. Remove body support.
3. Disconnect electrical connection then depress tab on
body support to remove damaged ON/OFF switch.
3.3.2.
Replacement
1. Place ON/OFF switch into body support and snap into
