packing.
Place
the
whole
assembly
in
the
dust
compartment.
3. Rewire per the Pictorial Diagram.
4. Replace the nozzle housing as instructed in Handle
Release Assembly sections and assemble the dust cover
and switch cover.
5. Turn the vacuum back over and replace the belt, agitator
assembly, and lower plate according to the respective
installation instructions.
3.10. Motor Protector Replacement
3.10.1. Removal
1. Remove the motor assembly and open the motor assembly
as out lined in the Motor Replacement section.
2. Using a flat screw driver remove the motor protector
assembly.
3.10.2. Installation
1. Install the new motor protector and reassemble the motor
assembly as instructed in the Motor Replacement section.
2. Install the dust cover, switch cover, nozzle housing, belt,
agitator and lower plate as instructed in the respective
removal sections.
3.11. Headlight Bulb Replacement
3.11.1. Removal
1. Using a flat screwdriver pry up light lens at slots.
2. Remove old bulb from the socket by pulling straight out.
3.11.2. Installation
1. Install the new light bulb and replace light lens.
15
MC-UG775-00
