15. Discard motor if defective.
3.4.2. Installation
1. Reconnect motor lead wires (refer to wiring diagram if
necessary).
2. Reinstall motor support rubbers, motor flange (MC-UG327
only) and noise suppressor.
3. Reinstall motor assembly into vacuum cleaner with thermal
protector facing down.
4. Route all wiring in accordance with wire management
drawing.
5. Reinstall plastic holder (MC-UG323).
6. Avoid pinching of the noise suppressor by installing with
overlap beneath motor and tuck excess material.
7. Reinstall nozzle and nozzle spring.
8. Reinstall motor cover. Make sure no wires are pinched and
the tabs snap into place.
9. Reinstall three (3) screws in the front of the vacuum cleaner
10. Turn vacuum cleaner over and reinstall two (2) screws into
back of vacuum cleaner.
11. Reinstall agitator (See Agitator - Installation) and lower
plate (See Lower Plate - Installation).
12. Reinstall upper body (See Upper Body - Installation)
13. Reinstall nozzle hose into vacuum cleaner body.
16
MC-UG323-00 / MC-UG327-00 /
