12
3.9.
Motor Assembly Replacement
3.9.1.
Removal
1. Remove the dust cover by removing the eight (8) screws.
2. Remove the lower plate, beater bar assembly, belt, the
plastic shaft and the nozzle housing as instructed in the
respective removal sections.
3. Disconnect the motor leads and remove the motor.
Remove the motor support rubber (rear), noise suppres-
sor and the motor support rubber (front).
3.9.2.
Installation
1. Place the motor back into the dust compartment with the
tabs on the motor support (rear) aligned parallel to the
front edge of the dust compartment.
2. Rewire per the Pictorial Wiring Diagram and Wiring Man-
agement Drawing.
3. Replace the dust cover and the eight (8) screws.
4. Replace the nozzle housing assembly, belt, beater bar-
beater bar assembly, and lower plate according to the
respective installation instructions.
