Panasonic KX-VC300CN, Руководство по установке

Страница: 43 / 64

6.6 Remote Access
Settings
It is possible to change the settings of the unit from a
separate location via remote access using an intranet.
The following network settings are required to enable
remote access.
Notice
•
Please gain permission from the customer
before performing the network settings.
Note
•
To perform the remote access settings, the unit
must be turned on.
•
The unit cannot be operated while the remote
access settings are being performed.
Making the Web Port Status Open
1.
Perform steps 1–7 in "Starting and Operating a
Terminal Emulator" (Page 37).
2.
Enter "httpenable set defenable 1", then press
[Enter].
3.
Enter "syssave", then press [Enter].
•
The value is saved as configuration data.
4.
Turn the power off, then back on, to restart the unit.
Allowing HTTP Access
Perform network settings so that the unit allows external
HTTP access for maintenance.
6.6.1 Updating Software
Note
•
Contact your dealer for more information on
obtaining the latest firmware and User Manual.
1.
From an external maintenance computer, start a
Web browser, then enter the IP address of the unit
in the URL field.
•
An authentication screen is displayed.
2.
Enter the login user name and login password.
•
The login user name is "admin" and the default
password is "HDVC_admin".
•
The Language Selection screen is displayed.
3.
Click [English] on the Language Selection screen.
•
The System Operation screen is displayed.
4.
Click [stop] under [Remote Maintenance
Commands]
®
[Communication service] on the
System Operation screen.
4
10
6
8
11
5.
Confirm that [OK] is displayed on the screen, then
click [Back] on the Web browser.
•
The System Operation screen is displayed.
Note
•
If [command not available] is displayed, the
unit is on a video conference call. Perform
the settings again after the video
conference call has finished.
•
If anything else is displayed, follow the
procedure below to restart the system, then
perform the settings again.
1.
Click [Back] on the Web browser.
2.
Click [restart] under [System Restart]
®
[System restart] on the System
Operation screen.
6.
Click [view] under [Remote Maintenance
Commands]
®
[Check system status] on the
System Operation screen.
7.
Confirm that [outOfService] is displayed on the
screen, then click [Back] on the Web browser.
•
The System Operation screen is displayed.
Note
•
If [active] is displayed, start again from step
4.
Installation Manual 43
6 Settings and Confirmation