Error messages
Display message
Cause/solution
Ask phone
company for
VM access #
R
You have not stored the voicemail access number.
Store the number (page 42).
Main unit
no power
or
No link. Re-
connect base
AC adaptor.
R
Confirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been canceled.
Re-register the handset (page 34).
Busy
R
The called unit is in use.
R
Other units are in use and the system is busy. Try
again later.
R
The handset you are using is too far from the base
unit. Move closer and try again.
Check tel line
R
The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 10).
Error!!
R
Recording was too short. Try again.
Memory full
R
The recording memory is full. Erase unwanted
recordings (page 38).
Invalid
R
There is no handset registered to the base unit
matching the handset number you entered.
R
The handset is not registered to the base unit.
Register the handset (page 34).
Requires
subscription
to Caller ID.
R
You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use
rechargeable
battery.
R
A wrong type of battery such as alkaline or
manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 7.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert them into the handset again.
46
For assistance, please visit http://shop.panasonic.com/support
Useful Information
TGD61x_63x(en)_0428_ver021.pdf 46
2021/04/28 11:28:14