Panasonic KX-TG7100ES, Руководство по обслуживанию

Страница: 54 / 83

54
KX-TG7100ES/KX-TG7102ES/KX-TG7103ES/KX-TGA710ES
11.6. Things to Do after Replacing IC
Cautions:
Since this page is common to each country, it may not apply to some models in your country. The contents below are the mini-
mum adjustments required for operation.
11.6.1. Base Unit
Before doing the following adjustment, be sure to do PC Setting (P.47) in The Setting Method of JIG (Base Unit) .
Note:
(*1) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in
JIG and PC
(P.47).
(*2) Refer to
Check Point (Base Unit) (P.34)
11.6.2. Handset
Before doing the following adjustment, be sure to do PC Setting (P.48) in The Setting Method of JIG (Handset) .
Note:
(*3) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in
JIG and PC
(P.47).
(*4) Refer to Check Point (Handset) (P.38)
IC Necessary Adjustment
BBIC
(IC7) Programs for Voice processing, interface for RF and
EEPROM 1. Default batch file: Execute the command “default.bat”.
2. Country version batch file: Execute the command
“TG7100XXrevYY.bat”. (*1)
3. Clock adjustment: Refer to Check Point (F). (*2)
EEPROM
(IC5) Adjustment parameter data
(country version batch file, default batch file, etc.) 1. Change the address “0000” of EEPROM to “00”.
2. Default batch file: Execute the command “default.bat”.
3. Country version batch file: Execute the command
“TG7100XXrevYY.bat”. (*1)
4. Clock adjustment: Refer to Check Point (F). (*2)
IC Necessary Adjustment
BBIC
(IC1) Programs for Voice processing, interface for RF and
EEPROM 1. Default batch file: Execute the command “default.bat”.
2. Default batch file (remaining); Execute the command
“TGA710 DEFrevYY.bat”. (*3)
3. Country version batch file: Execute the command
“TGA710XXrevYY”. (*3)
4. Clock adjustment: Refer to Check Point (J). (*4)
5. 1.8 V setting and battery low detection: Refer to Check
Point (A), (H) and (I). (*4)
EEPROM
(IC3) Adjustment parameter data
(country version batch file, default batch file, etc.) 1. Change the address “0015” of EEPROM to “00”.
2. Default batch file: Execute the command “default.bat”.
3. Default batch file (remaining); Execute the command
“TGA710 DEFrevYY.bat”. (*3)
4. Country version batch file: Execute the command
“TGA710XXrevYY”. (*3)
5. Clock adjustment: Refer to Check Point (J). (*4)
6. 1.8 V setting and battery low detection: Refer to Check
Point (A), (H) and (I). (*4)