Registration
48
Registering a Handset in the Base Unit
You must register the handset in the base unit before use.
1
Base unit where handset is to be
registered:
Press and hold
on the base unit
for more than 10 seconds until the in
use indicator (
) lights and a
confirmation tone sounds.
2
Handset:
Press .
3
Press
G
or
F
until “
F7 i
” is displayed.
4
Press .
•
The available base unit numbers are
displayed.
5
Press the desired base unit number
to .
•
The number is assigned as the base unit
number for the handset.
•
While the handset is searching for the
base unit, “
-
” flashes across on the
display.
4
1
OK
•
Charge the optional handset batteries for about 4 hours before initial use.
•
Make sure that the power is ON (p. 13) and the unit is in the stand-by mode.
•
Register the handset number within 1 minute. If not registered within 1 minute, press
on
the handset to cancel the programming mode. Then start again from step 1.
•
The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 51). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
6
Enter the base unit password (p. 29).
7
Press .
•
A confirmation tone sounds and the
display will return to the stand-by mode.
•
The in use indicator (
) on the base
unit will go out.
•
To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
F7 i
U
i234
F7 i
o
- - - -
-
KX-TCD961CXB(47~56) 99.12.3 2:20 PM Page 48
