18
Preparing the Answering System
Programming Summary for the Answering System
You can program function items using the handset near the base unit. See the corresponding pages
for function details.
Make sure that the power is ON (p. 13) and you are in the stand-by mode.
<Stand-by mode>
Press then .
I N T
Enter a desired function command as shown below.
Command
0
1
2
Function item
To adjust the time and day (p. 19)
To set the remote code (p. 42)
To select the number of rings
(p. 21)
Command
3
4
6
Function item
To select the caller’s recording
time (p. 20)
To set the greeting monitor
function (p. 21)
To select the voice guidance
language (p. 16)
Press .
- i-
•
If “
” flashes on the handset display and an alarm tone sounds, move closer to the base unit and
try again.
•
To cancel during programming, press
. Start again from the beginning.
•
To return to the previous step during programming, press
.
•
When programming is completed, a confirmation tone sounds.
*
•
If 6 beeps sound on the base unit during programming, a wrong key was pressed. Enter the correct
number.
*What the confirmation tone means
1 beep:
The new programmed setting or selection is done.
2 beeps: The setting or selection is the same as the previous one.
6 beeps: The setting or selection is not correct. Try again from the beginning.
C
KX-TCD961CXB(17~21) 99.12.3 2:06 PM Page 18
