Useful Information
46
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Initial settings
Problem
Cause & solution
w
is flashing.
L
The handset is not registered to the base unit.
Register it (page 38).
L
The handset is too far from the base unit. Move
closer.
L
The AC adaptor is not connected. Check the
connections.
The handset display is blank.
L
The handset is not turned on. Turn the power on
(page 11).
The handset will not turn on.
L
Make sure that the batteries are installed correctly
(page 10).
L
Fully charge the batteries (page 10).
L
Clean the charge contact and charge again (page
10).
The display is dark and displayed
items are very faint.
L
The handset is in screen saver mode (page 11).
TCD300CX(e).book Page 46 Monday, January 31, 2005 1:49 PM