Base Unit Settings
26
Storing area codes here will prevent the
restricted handsets from dialling any phone
number in that area code. If a restricted
number is dialled, the call will not be
connected and the restricted number will
flash on the display.
1
Press
{j
/OK
}
.
2
Select
“
Base Unit Setup
”
, then
press
{>}
.
3
Enter
“
0000
”
(default base unit PIN).
L
If you changed the PIN, enter it (page
26).
4
Select
“
Call Options
”
, then press
{>}
.
5
Select
“
Call Restrict
”
, then press
{>}
.
6
Set which handsets will be restricted by
pressing the desired handset number.
L
All the registered handset numbers
will be displayed.
L
Flashing numbers indicate call
restriction is turned on for the
corresponding handset.
L
To turn call restriction off for a handset,
press the number again. The number
will stop flashing.
7
Press
{j
/OK
}
.
8
Select a memory location, then press
{>}
.
L
If the memory location already
contains a restricted number, the
number is displayed.
9
Enter the phone number or area code to
be restricted (8 digits max.), then press
{j
/OK
}
.
L
To erase a restricted number, press
{
C/
T
}
.
10
Press
{ih}
.
Other options
Changing the base unit PIN
(Personal Identification Number)
For security, the base unit PIN must be
entered when changing certain settings. The
default PIN is
“
0000
”
.
Important:
L
If you change the PIN, please make note
of your new PIN. The unit will not reveal
the PIN to you. If you forget your PIN,
consult your nearest Panasonic service
centre.
1
Press
{j
/OK
}
.
2
Select
“
Base Unit Setup
”
, then
press
{>}
.
3
Enter
“
0000
”
(default base unit PIN).
L
If you changed the PIN, enter it.
4
Select
“
Other Options
”
, then press
{>}
.
5
Select
“
Base Unit PIN
”
, then press
{>}
.
6
Enter the new 4-digit base unit PIN, then
press
{j
/OK
}
.
7
Press
{ih}
.
Resetting the base unit to its
default settings
1
Press
{j
/OK
}
.
2
Select
“
Base Unit Setup
”
, then
press
{>}
.
3
Enter
“
0000
”
(default base unit PIN).
L
If you changed the PIN, enter it (page
26).
4
Select
“
Other Options
”
, then press
{>}
.
5
Select
“
Reset Base
”
, then press
{>}
.
6
Select
“
Yes
”
, then press
{>}
.
TCD200FX(e-e).book Page 26 Monday, February 7, 2005 1:19 PM
