17
Installation of Lightning Protectors
Installation of the KX-A207
1. Secure the protector to a building with the
enclosed mounting screws.
4. Fold the external and internal cables, and
connect them to the terminal screws using
washers.
Power Failure Transfer
In the event of a power failure, CO1 is connected to extension 21 and CO2 is connected to
extension 22 automatically.
Note
• The system programmed data is protected by the factory provided lithium battery.
Starting the System
Plug the AC power cord into the system and an AC outlet.
• The power indicator of the system will light.
2. Remove about 1 cm (
13
/
32
inch) of insulation
from the end of the earth wire. Insert the
earth wire through the bottom of the protec-
tor base and secure it to the earth terminal.
3. Remove about 1.5 cm (
19
/
32
inch) of insula-
tion from the ends of the external and inter-
nal cables, then pass the cables through the
rubber packing.
5. Secure the external and internal cables and
the earth wire to the building. Then, install
the arrester and mount the cover on the
protector.