Panasonic KX-HTS Series, Руководство пользователя

Страница: 57 / 91

3.5 Connecting Extensions
3.5.1 LAN Connections for IP Telephones
When an IP telephone is connected to the LAN and power is supplied for the first time, you will be prompted
to set network parameters. The network parameters must be set for the IP telephone before it can be used.
Connecting an IP Telephone to a Switching Hub
When connecting an IP telephone to the LAN, connect it to a switching hub.
Note
• Use an Ethernet straight cable with an RJ45 connector to connect the IP telephone to a switching hub.
The cable should be a CAT 5 (Category 5) or higher for 10BASE-T/100BASE-TX, or CAT 5e (Enhanced
Category 5) or higher for 1000BASE-T.
• When using the VLAN feature on the network, make sure that the switching hub to be connected is
IEEE 802.1Q compliant and is configured for VLANs. In addition, the port of a switching hub that the
IP telephone is connected to must be set to "Trunk" port, to allow VLAN tagging. Consult your network
administrator for details.
• Since an IP softphone is installed and operates on a PC, the PC must be connected to the LAN to use
the IP softphone on the network.
The diagram below is for connecting an P-SIP to a switching hub. For SIP phones, refer to the documentation
of your SIP phone.
Example: KX-HDV230
Ethernet Straight Cable
Connecting an AC Adaptor to an IP Telephone
Some SIP phones comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is
available on your network, these IP telephones can receive the necessary power supply from the network
through the network cable. In this case, an AC adaptor is not needed for the IP telephone.
However, if PoE is not available, you will need to connect an AC adaptor to the IP telephone.
Note
Use only the specified type of AC adaptor for each IP telephone. For details, refer to the documentation of
your IP telephone.
To a Switching Hub