![background image](http://html1.mh-extra.com/html/panasonic/kx-hnc710w/kx-hnc710w_installation-manual_3793597017.webp)
Confirming the
camera installation
area
Before deciding where to install
the camera, carefully read the
chapter “Installation Location”,
beginning on page 10, to confirm
the installation location and
direction.
Installation
Installation precautions
R
Do not use an impact driver.
(This may lead to damaged
screws or over-tightening.)
R
Mount the camera on the stable
location with a height of 2.2 m
(7 feet 3 inches) where the unit
can be adequately supported
when installing.
R
Do not mount the camera on a
soft material. It may fall down,
break or cause injury.
Wall material information
Siding
R
Use the included screws ø4 mm
´
25 mm (ø
5
/
32
inches
´
1 inch).
Make sure the pull-out capacity
of each screw is at least 294 N
(30 kgf).
R
If the weight of the camera is
supported by the siding only,
the siding could become
damaged. Make sure you
mount the camera in a location
where the structure behind the
siding can be used to support
the weight of the camera. If this
is not possible due to the
thickness of the siding, use
commercially-available screws
ø4 mm
´
longer than 25 mm
(ø
5
/
32
inches
´
longer than
1 inch).
R
Drill a pilot hole using a drill bit
that is appropriate for the type
of siding. Remove any debris
after drilling the pilot hole. Do
not drill the pilot hole into the
structure behind the siding.
Poor
example
No support
behind
exterior
surface
Ideal
example
Structure
supports
exterior
surface
1
2
3
2
1
Open space, no support
For assistance, please visit http://shop.panasonic.com/support
17
Setup
HNC710_(en_en)_0207_ver.110.pdf 17
2018/02/07 20:11:47
Содержание KX-HNC710W
Страница 26: ...26 Notes HNC710_ en_en _0207_ver 110 pdf 26 2018 02 07 20 11 47 ...
Страница 27: ...27 Notes HNC710_ en_en _0207_ver 110 pdf 27 2018 02 07 20 11 48 ...
Страница 43: ...15 Notas HNC710_ es_es _0208_ver 110 pdf 15 2018 02 08 20 45 11 ...
Страница 44: ...HNC710_ es_es _0208_ver 110 pdf 16 2018 02 08 20 45 11 ...