39
PROVISIONING – UPGRADE AND CONFIGURATION
8SJUDGLQJIURPGRZQORDGHG¿OH
,WLVSRVVLEOHWRGRZQORDGD¿UPZDUH¿OHIURP
https://panasonic.net/cns/pcc/support/sipphone/
and install it on the KX-HDV800
from the local hard disk.
Ö
'RZQORDGWKH¿UPZDUH¿OHIURP
https://panasonic.net/cns/pcc/support/sipphone/
.
Ö
Click on the
Browse
«EXWWRQDQGORFDWHDQGVHOHFWWKHGRZQORDGHG¿OH
Ö
Click on the
Upgrade
button.
Upgrading from SD card (sold separately)
Upgrading from SD card may be suitable if you have many phones to upgrade. The
phones do not have to be connected to the network.
Ö
'RZQORDGWKHODWHVW¿UPZDUHDVDERYHDQGVDYHLWRQD6'FDUG
Ö
Put the SD card in the phone you want to upgrade.
Ö
Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.
Ö
Press and hold the
(MENU)
button while you connect the cable again (i.e. starts
the KX-HDV800). Hold the button pressed until the SYSTEM RECOVERY menu is
shown on the display.
L
You can press any other button than
1
,
2
, or
3
to start the phone without any
change.
Ö
Press
2
to select
SD-card upgrade
.
7KH.;+'9LVXSJUDGHGZLWKWKH¿UPZDUH¿OHRQWKH6'FDUGDQGVWDUWVZKHQWKH
upgrade is done.
After upgrading
If DHCP is used in the network, the IP address may have been changed. If the web
browser loses contact with KX-HDV800, check the IP address on the conference phone
(see “USING THE WEB INTERFACE” on page 8).
USING A CONFIGURATION FILE
,WLVSRVVLEOHWRVDYHDFRQ¿JXUDWLRQ[PO¿OHWREHXVHGDV
• Backup (i.e. if the system has been reset to factory default)