24
Rev.1.0
Charging a battery
1 Turn off all microphones.
2 Connect the micro-USB plug of the charger to the DC input terminal of the
microphone.
After connecting the microphone to the charger, the charge indicator (red) indicates the
charging status as follows:
ON:
Charging completed .
OFF:
, No connected a charge connector or no battery installed.
Blinking (
2 seconds ) : Charging
*
In the case of a complete discharge state, the first about 1minute red
LED lights
RED.
Blinking(
1 second ) : Charge Error.
Indicates one of the following conditions.
• The temperature of the battery may be out of the acceptable range. Confirm that the
temperature is within the acceptable range.
Important:
• If the microphone is connected to the charger with the power turned on, the microphone
will be powered off and charging will start.
Only E2 button operates during charge connector connection.
Note:
• If the charger remains connected after charging is completed, it will not restart charging to
make up for any amount lost due to self-discharge.
• If the microphone is turned off and the charger is connected, but the charge indicator does
not light, check to see that the micro-USB plug of the charger is properly plugged into the
DC input terminal, the power cable of the charger into the charger.
• Charging takes up to 4 hours, but the charging time varies depending on status of use.
• Charging at a temperature outside the normal range may result in significantly longer
charging times.
Note, however, that charging times may become longer even within the operating
temperature range, if the temperature of the microphone is higher or lower than the normal
condition.
• The charger and the microphone may get hot slightly during charging.
• Do not charge a rechargeable battery that has just been fully charged. Otherwise you will
shorten the life of the battery.
• Also read the operating instructions of the charger.
1.
[PWR/MUTE] button
Charge indicator
DC input terminal
2
