Attaching the roll paper
1.
Cut about 10 cm off the end of new roll paper.
2.
Press up on the part labeled "PUSH" on the printer cover (
A
), and pull up to open (
B
).
3.
Set the roll paper into the roll paper compartment (A).
•
Set so that the protrusion of the roll paper holder (B) is inserted into the center of the roll paper.
•
Set the roll paper so that the end faces out as shown in the figure. The unit cannot print if the roll
paper is set in the opposite direction.
B
A
4.
Pull out the roll paper so that about 1 to 5 cm of the end is out from the printer cover.
•
Pull out the roll paper straight. Pulling at an angle will cause paper jams.
5.
Gently lift and close the printer cover so that the roll paper does not fall out from the compartment
(
A
), and press the sides in the direction of the arrow until you hear a click (
B
).
•
The cover will not close if the roll paper is removed from the roll paper holder. Set the roll paper
again instead of forcefully trying to close it.
Operating Instructions - Reference Manual
13
Getting started
