Panasonic JT-B1 series, Руководство по эксплуатации

Страница: 14 / 60

Read Me First
14
Regulatory information
For U.S.A.
<Models for U.S.A.>
Federal Communications Commission
Radio Frequency Interference Statement
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
x p
Reorient or relocate the receiving
antenna.
x p
Increase the separation between the
equipment and receiver.
x p
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
x p
Consult the Panasonic Service Center or an
experienced radio/TV technician for help.
Warning
To assure continued compliance, use only
shielded interface cables when connecting
to a computer or peripheral. Also, any
changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
FCC RF Exposure Warning:
x p
This device meets the government’s
requirements for exposure to radio
waves.
This device is designed and
manufactured not to exceed the
emission limits for exposure to radio
frequency (RF) energy set by the
Federal Communications Commission of
the U.S. Government.
x p
This equipment has been approved for
portable operation, and does not require
any minimum spacing be provided
between antennas and all person’s body.
This equipment may not be colocated
or operated with any other antenna or
transmitter.
x p
The exposure standard for wireless
device employs a unit of measurement
known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is
1.6 W/k g .
x
* Tests for SAR are conducted
using standard operating positions
accepted by the FCC with the
device transmitting at its highest
certified power level in all tested
frequency bands. Although the SAR
is determined at the highest certified
power level, the actual SAR level of
the device while operating can be
well below the maximum value. This
is because the device is designed to
operate at multiple power levels so as
to use only the poser required to reach
the network. In general, the closer you
are to a wireless base station antenna,
the lower the power output.
JT-B1_eng(PGQX1334ZA)_20130122.indd 14 2013/01/22 9:10:07