12
Using a Grounding Clip with bolt
and nut
(see Figure 6.4)
Use Tyco Electronics 1954381-2 as
grounding clip.
Place the grounding clip onto the
module frame.
Thread the hex nut onto the end of
the screw, then using a 3/8-in.
wrench, tighten the nut.
Recommended torque value in
tightening bolt and nut is between
1.7 and 2.2 Nm.
Insert the wire into the wire slot.
Press down on both ends of the
wire.
Manually, or using channel lock
pliers, push the slider over the base
until it covers the base. This will
terminate the wire.
For more information, please refer to
Instruction sheet issued by Tyco Electron-
ics.
Note: Use the ground holes
illustrated in Figure 6.1.
Grounding Clip Assemblies:
Tyco Electronics 1954381-2
Figure 6.4
Using a Grounding Clip with bolt and nut