Panasonic GT703, Руководство пользователя

Страница: 84 / 105

Troubleshooting
5-8
Code no. Error Cause and solution
**1006
SD memory card recognition
error
The SD memory card cannot be recognized. Check the SD
memory card used.
**1020 PLC model unmatch error
Check if the PLC program for transfer matches the destination
PLC.
**1021 PLC model unsupported error
The selected PLC model is not supported. Confirm the PLC
model.
**1022 Password protection error
Incorrect passwords were input three times or more. Turn on the
power supply again, and enter the correct password.
The upload protection has been set for the PLC.
The number of digits was changed when setting a new password
with the FP monitor function. Cancel the password setting first to
change the number of digits.
**1023
Master memory installation
error
A master memory is installed in the PLC (FP-X). Programs
cannot be transferred to the PLC with the master memory from
a SD memory card.
**1024 Program memory shortage
Program memory shortage in the destination PLC. Decrease the
program size using the PLC tool.
**1025
General-purpose memory
shortage
General-purpose memory shortage in the destination PLC.
**1027 Remote mode error
The PLC (FP2/FP2SH) is set to the RUN mode. Change to the
REMOTE mode or PROG. mode.
**102D Forced operation error
Check if a device that cannot be forcibly operated in the PROG.
mode has been forcibly turned on or off.
**1040
The record area for logging
was overwritten.
Check if an SD memory card is inserted.
**1041
Data cannot be written into the SD memory card. Check whether
the SD memory card is not write-protected.
**1042
The memory of the SD memory card is full. Delete some data in
the SD memory card or prepare a new SD memory card.
**1044
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1043 SD memory card writing error
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
**1045
The record area for logging
cannot be reserved in the
RAM.
Transfer all data.
**10A0 ROM write error
The firmware file loaded from the SD card is damaged.
Recreate the file in the SD card.
**1060 Index register value error
The device value for index modifier is out of the setting range.
Check the setting value.
**1080 Start time device value error
The value at the start of the line graph function is out of the
setting range. Check the setting value.
**1100
Ethernet IP address setting
error
The IP address for Ethernet is not specified correctly. Check the
IP address for the GT.
**1101
Ethernet subnet
mask setting error
The subnet mask for Ethernet is not specified correctly. Check
the subnet mask for the GT.
**1102
Ethernet default
gateway setting error
The default gateway for Ethernet is not specified correctly.
Check the default gateway for the GT.
**1103
Ethernet port number
setting error
The port number for Ethernet is not specified correctly. Check
the port number of the GT.