(1) excessive bending
(2) multi-times bending
(3) reduction the diameter of connecting duct
■
Please avoid the following duct installation.
■
It may cause the unexpected accident.
安装注意事项<必须遵守>
请避免以下现象。
过分弯曲
多次弯曲
缩小连接管道直径
易引发意想不到的事故。
禁止
禁止
禁止
Provide an exclusive circuit breaker that
can completely contacts on all the poles
by more than 3mm through direct
connections to the power terminals.
Depending upon the environment for
installation, it becomes necessary to
install an earth leakage breaker.
Don’t install the unit in locations such
as machinery, chemical and research
plant where it will be exposed to
noxious gases containing acids, alkali,
organic solvents, paint fumes, etc., to
gases containing corrosive ingredients.
It may cause the gas poison, corrosive
damage and deterioration inside the unit,
result in fire.
Please don’t install the unit in location
where indoor temperature is below the
outdoor temperature.
It may cause the electric shock or
abnormal operation.
Don’t insert fingers or sticks into the unit
or air inlet, air outlet.
It may cause the injury because of high
speed rotation inside the unit.
Don’t install in location where may be
exposed to the combustible gas leakage.
In case of gas get together around the unit,
it may cause the fire.
请勿将主机及室内进风口安装在机械厂、化学
工厂及研究设施等产生酸、有机溶剂、涂料等
有害气体和含有腐蚀性成分气体的地方。
易引起气体中毒，主机内部腐蚀、劣化
而引发火灾。
请勿将机器安装在室内温度明显低于室外温度
的环境中。
易引发触电或异常操作。
安装时必须在供电线路中安装其断开触点距离
不小于3
mm
的全级断开装置。按照安装环境的
不同，可能有必要安装漏电断路器。
请勿将手指或棍棒插入主机或送风口、排风口。
由于设备内部高速旋转，易导致受伤。
请勿安装在可能存在可燃气体泄露的地方。
如果气体聚集在主机周围可能引起火灾。
CAUTION
注意
Connect the power cord and the lead
wire with accuracy using the specified
wires and fix them firmly so as not to
put the outer stress of wires on the pin
connecting area. Incomplete connection
or fixing is likely to cause a heat
generation or fire.
电源线和连接线要使用指定的电缆连接牢固，
端子连接部位要固定结实，不受电缆外力影
响。
Please take care of it during moving
the unit.
Improper hanging and moving may
cause the dropping, result in injury.
搬进、搬出时，请注意重心及重量。
如吊装和抬起不当时，易引发产品掉
落、造成受伤。
禁 止
禁 止
禁 止
禁 止
禁 止
