INSTALLATION
2. installing the wall control
(1) Open the knock-out hole and remove
maintenance plate 1 and 2 and wiring
cover.
Wiring cover
(3) Insert cables into the corresponding
terminals of product. Make sure the
lead wire labels correspond to the
terminal label and the screw of
terminal securely fastens the copper
wire and no copper wire is exposed
(5) Remove the face plate backing cover
from the backing plate with a small flat
screwdriver.
----
Flat screwdriver
Face plate
backing cover
(7) Remove the face plate backing cover,
cut the terminal hole and drill screw
holes (<D5/32 ft (<D4 mm)).
(8) Insert wall anchors, and fix the face
plate backing cover on the wall with
two screws.
Drill screw hole
m
......
Terminal hole
-5-
(2) Thread cables through conduits
respectively and install the
conduits into knock-out holes.
(4) Re-install the wiring covers and
maintenance plates.
(6) Temporarily put the face plate backing
cover on the wall, mark terminal hole
and screw positions.
Wall
Unit inches (mm)
3/16 (4.8)
7 /8x1 /2 (22x12.5)
(9) Route the cables form the unit to
the terminal hole.
Wall
Cables
Face plate
backing cover
